Most frequently asked questions for beginners
Q: What are the different LTspice file types?
Schematic: name.asc the drawing with your circuit Symbol: name.asy symbols for the schematic Logfile: name.log infos and results from .four, .measure, .op Netlist: name.net you don't care about Result: name.raw usually a binary file Result: name.fft result of an FFT, usually a binary file Plot settings: name.plt Model file: abc.xyz contains the models, any file name Symbol: name.cir if you have a netlist input file
Q: How can I add intrinsic device models (BJTs, FETs, etc.) to LTspice?
A: Please take a look to the many examples in the section "Files > Lib".
Q: How can I add subcircuits to LTspice?
A: You WILL find many answers when you search the messages for words like library, symbol or FAQ.
Please read first the programs help: Help ->Schematic Capture -> Editing Components -> Creating New Symbols Help -> Help Topics ->FAQs -> Third party models Help -> Help Topics ->FAQs -> Mosfet You will find also help in the linked documents from our LTspice Yahoo group. Links Links > Spice Courseware And Tutorials There is another document about symbols and models in our Files section. Files > Tut > Symbol Types For Subcircuits
Q: How do you copy and paste between schematics?
A: Click on "Copy" in the tool bar. Select what you want to copy. Make the other schematic active and then click on "paste" in the tool bar."
Q: How do I copy and paste between symbols in the symbol editor?
A: It is not possible to use copy and paste in the symbol editor. Symbol files are ASCII-text. Merge the text as described in message 7201 in the Yahoo Group. [1]
Q: I have a pulse source in my schematic with zero transition times. LTspice only shows slow transition times of 2ns. What's going on here?
PULSE(0 5 0 0 0 20n 100n)
A: LTspice automatically will use a default value for <trise> and <tfall> if these parameters are set to zero. Default value: 10% of Ton or 10% of Tperiod-Ton whatever is smaller. You have to specify Trise and Tfall if you want a certain value.
PULSE(0 5 0 100p 100p 20n 100n)
Don't use steeper transitions than required by your application.
Q: I have used a pure sine source in my schematic, but the output signal of my circuit looks slightly different from cycle to cycle.
A: LTspice has waveform compression enabled as the default setting. This compression reduces the amount of saved data during the simulation. It's a lossy compression and thus it can distort the saved signals. You can switch it off with the following command line in your schematic.
.options plotwinsize=0
It could be switched off in the "Control Panel -> compression" pane as well, but this setting will be lost after a new invocation of LTspice.