The Chan model

From LTwiki-Wiki for LTspice
Revision as of 06:51, 5 February 2015 by Jose luu (talk | contribs) (example)

The Chan model is a hysteretic core model based on a model first proposed in by John Chan et al. in the IEEE Transactions On Computer-Aided Design, Vol. 10. No. 4, April 1991 but extended with the methods in United States Patent 7,502,723.  Compared to older core models, the Chan model is particularly robust, computationally efficient and compact, requiring only three parameters to define most any commonly encountered magnetic hysteresis loop.

Once the core material's generic magnetic properties are set, establishing the circuit-level non-linear inductance requires specifying three more parameters to set the geometry of the specific core and one additional parameter to set the core winding turn-count.  The Chan model as implemented in LTspice does not directly support Mutual Inductance, so unless only a single-winding inductor is being modeled, multiple windings must be added on via additional circuitry.

This page is incomplete.  Perhaps a link to the original paper should be given along with some discussion of how the model works and why and how it is more robust and computationally efficient than other core models.  Equations supported with illustrative graphs would be helpful.


Ferrite bead inductor using fair rite 73 material ref 2673000101

Instead of entering 1.5uH as inductor value, use Hc=19.1 Bs=.39 Br=.15 A=3.575u Lm=6.9m N=1 Lg=0

Parameters are derived from the fair-rite documentation page as follows:

  • HC is the coercive force in A/M and should be the A/M equivalent of 0.24 Oersted (multiply by 1000 and divide by 4*PI)
  • BS is the saturation in Tesla and should be the Tesla equivalent of the 3900 Gauss value (divide by 10000) giving .39T
  • Br is the remanence (remnant) and should be the Tesla equivalent of the 1500 Gauss value
  • A is the bead magnetic cross section, use dimensions C*(A-B)/2, area is in mm2 hence the u
  • Lm is the length of the magnetic flux lines in meters, use PI*(A+B)/2
  • N is the number of turns, use value between 1 and 0.5 in the case of a ferrite bead
  • Lg=0 since we have no gaps